Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Flatbush
Flatbush chimneys take a beating that has little to do with wood smoke. Most of the stacks on these 1900s limestone rowhouses and 1920s brick apartment buildings are original, and a good number were abandoned when the building switched to gas or oil. A cracked crown or a rusted-out cap on a stack like that is a moisture problem first and a fire-safety problem second, and both get worse the longer they sit. We handle chimney cap and crown work across Flatbush, from the tight side streets off Church Avenue to the rowhouse blocks near Prospect Park. Call (855) 924-3713. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Flatbush Homeowners Call Chimney Sweep Bensonhurst for Chimney Cap & Crown
Flatbush has a particular chimney problem, and it rewards a company that reads it correctly. On attached limestone and frame rowhouses, the stacks sit close together across party walls, so a crown that fails on one building sends water into masonry that may already be shared or adjacent. We see that pattern constantly, and we plan cap and crown work around it rather than treating each stack as an isolated job.
We’re a full-scope chimney and fireplace specialist. Cap and crown work sits alongside sweeping, inspection, chimney repair, and fireplace repair, which means the technician who diagnoses your crown can also scope the liner and smoke chamber on the same visit. We specify trade-grade components from DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield, matched to how your particular stack is built.
Our technicians have up to 12 years of experience. We don’t claim a founding date or a review count we can’t back up; what we can tell you is how the job goes, what we check, and what the written estimate covers before any work starts. If you’re looking for Flatbush chimney work, call (855) 924-3713.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Flatbush
Dense attached housing changes what “cap and crown” actually involves. Below are the four services we do most on Flatbush rowhouse and apartment-building stacks, and how each plays out here.
Cap Installation in Flatbush
A correctly sized cap keeps rain, birds, and squirrels out of a flue that may be serving nothing but a water heater. On Flatbush’s tightly spaced stacks, fit matters: an undersized cap leaves the flue mouth exposed, and an oversized one can interfere with the draft an appliance depends on. We measure the flue opening and match the cap to the actual stack, not to whatever’s on the shelf. Call (855) 924-3713 to book an install.

Cap Replacement in Flatbush
Original caps on these rowhouses are often galvanized steel that’s rusted through after decades of humid coastal air and winter freeze-thaw. Once the mesh or the top plate goes, the stack is open to weather and wildlife. We remove the failed cap, inspect the flue below it while it’s exposed, and fit a replacement sized to the flue. Any pitting or spalling visible at the rim gets noted in the report.

Crown Repair in Flatbush
The chimney crown is the concrete or mortar cap that sheds water away from the brick below. On 1900-1940 Flatbush rowhouses, original brick crowns crack at the mortar joints under repeated freeze-thaw, and because the stacks sit close across party walls, that water damage can spread toward the neighbor’s flue. Repair restores the overhang and drip edge so water runs off the stack instead of into it.

Crown Coating in Flatbush
Where the crown is cracked but structurally sound, a coating seals the surface and buys years before a rebuild is needed. We use HeatShield ceramic systems where the crown is a good candidate; a badly fractured or crumbling crown isn’t, and we’ll say so. Coating works best on a crown that still has its shape and slope intact. Call (855) 924-3713 for a coating assessment.
Trusted Brands We Service in Flatbush
We work with professional-grade, industry-recognized brands: DuraFlex for flexible liner systems, HeatShield for ceramic flue resurfacing, Gelco for liner and cap components, Olympia Chimney, Famco, and Copperfield for caps and crowns. We draw from multiple supply lines because a shared Flatbush stack and a standalone Victorian chimney don’t call for the same fitting. If your existing cap or crown is one of these brands, we can match a replacement without tearing out what’s still sound. Fast turnaround on standard sizes.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Flatbush Homes
- Cracked brick crowns on 1900-1940 stacks. Years of freeze-thaw open mortar joints at the crown, and water gets in. On attached rowhouses, that damage can reach the neighbor’s flue because the stacks sit so close.
- Rusted-out caps on abandoned flues. Plenty of Flatbush flues were capped when the building went to gas. Once that old cap fails, the stack is open to rain, promoting spalling brick and, sometimes, a partially collapsed liner no one can see from the ground.
- Cross-contamination on shared stacks. In attached limestone rowhouses, a neighbor’s appliance venting into an adjacent flue can push exhaust back down a badly capped or unsealed stack. That’s a draft problem and a carbon monoxide concern.
- Spalling brick on dormant chimneys. A flue nobody burns in still takes on moisture through the open top and through the brick itself. Dormant summer flues plus humid coastal air are a bad combination for masonry.
Pricing for Chimney Cap & Crown in Flatbush, NY
These are typical ranges for Flatbush, not a quote. A standard single-flue cap installation usually runs $180 – $380. A custom or multi-flue cap for a shared stack runs $400 – $900. Crown coating typically runs $350 – $700. Crown repair or a partial rebuild usually runs $600 – $1,400.
| Service | Typical Flatbush range |
|---|---|
| Single-flue cap installation | $180 – $380 |
| Custom or multi-flue cap | $400 – $900 |
| Crown coating | $350 – $700 |
| Crown repair or partial rebuild | $600 – $1,400 |
Cost depends on roof access, stack height, how many flues share the crown, and whether the liner underneath is sound. The written estimate sets the final price. Estimates are free. Call (855) 924-3713.
We Also Serve Cities Near Flatbush
We cover chimney cap and crown work across Flatbush and the surrounding areas, including Kensington, Flatlands, Midwood, and Borough Park. The rowhouse and brick-apartment stock carries across these neighborhoods, so the same read on attached stacks and party walls applies. Our chimney cap & crown team handles every one of these calls the same way.
Serving Flatbush, NY – Our Local Coverage Area
We serve Flatbush and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Flatbush
Yes. An abandoned flue still takes on water through an open top, and moisture is the main thing that damages dormant masonry. A sound cap and crown keep rain out and slow the spalling that would otherwise spread to the brick below. Call (855) 924-3713 for an exact quote; estimates are free.
It can. On attached Flatbush rowhouses, tightly spaced stacks share the same air and closely set flues, so a badly capped or unsealed stack can let exhaust from an adjacent appliance push back down. That’s a cross-contamination and carbon monoxide concern, not just a draft nuisance. Call (855) 924-3713 and we’ll scope both stacks.
Coating fits a crown that’s cracked at the surface but still has its shape and slope. A badly fractured or crumbling crown needs a rebuild. The difference is visible in the inspection: we check the mortar joints, the overhang, the drip edge, and whether water is already reaching the liner. Call (855) 924-3713 to book the inspection.
Because freeze-thaw and humidity do the damage, not fire. Flatbush’s winter cycles pull moisture into the brick, and that moisture expands as it freezes. Over years, the surface flakes and spalls. An open top or a cracked crown lets more water in, which speeds it up. Call (855) 924-3713 to have the stack looked at.
It covers every flue on the stack in one housing, so each opening stays sealed while sharing one weatherproof top. On a shared Flatbush stack with two or three flues serving different appliances, that’s what fits. A single cap leaves the other openings exposed. Call (855) 924-3713 for sizing and a free estimate.
If your Flatbush chimney crown is cracked, your cap is rusted through, or you want the stack scoped before the next freeze, call (855) 924-3713 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. One call covers sweep, inspection, cap and crown, chimney repair, and fireplace repair. Call Chimney Sweep Bensonhurst.
Written by the team at Chimney Sweep Bensonhurst.