Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Inspection Across Kensington
If you heat with wood or gas in Kensington, your chimney is a venting system first and a piece of masonry second. We inspect both parts. A typical chimney inspection in Kensington runs $150 – $450 depending on the level, and a Level 2 camera inspection, the one most older homes here actually need, usually lands between $250 and $400. Our technicians have up to 12 years of experience reading the coal-era stacks common on these blocks, and we show you the camera footage before we recommend anything. Call (855) 924-3713 for a free estimate.
Why Kensington Homeowners Call Chimney Sweep Bensonhurst for Chimney Inspection
Kensington is a neighborhood of early-20th-century single-family and two-family houses, and its chimneys were built for a different era of heating. Many of these stacks still carry clay tile liners, and a good number were never lined at all. Those flues started life venting coal, then oil, then gas, and each conversion left a little more wear behind. When we inspect a chimney on a street off Church Avenue or near Ocean Parkway, we’re looking at a venting history, not just a chimney.
That history is why camera evidence matters here more than almost anywhere. We connect homeowners in Kensington with independent local professionals who are licensed and insured as their state requires, and the inspection report is theirs to keep: photos, footage, and a plain explanation of what’s sound and what isn’t. If work can safely wait a season, we say so. Nothing gets recommended without the images to back it up.
Response to Kensington is quick, and booking a sweep or inspection is straightforward. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Inspection Services in Kensington
Our chimney inspection work in Kensington covers the full range, from a quick visual check to a camera survey of every flue. Here’s how each level works and when it applies to a Kensington home.
Level 1 Inspection
A Level 1 inspection is a visual check of the readily accessible parts of the chimney: the firebox, damper, flue from the top and bottom, and the exterior where it meets the roof. For a Kensington home that’s been inspected recently and hasn’t changed appliances or had a chimney fire, this often covers it. It’s the baseline, and it’s usually bundled with an annual cleaning.
Level 2 Inspection
A Level 2 inspection adds a video camera run through the flue, and in Kensington it’s the one we steer people toward most often. The neighborhood’s two-family houses commonly have a single stack serving two or more flues, and a camera is the only way to see whether those flues are properly separated or whether exhaust from one appliance is drifting into another. A Level 2 is also standard when a property changes hands.
Level 3 Inspection
A Level 3 inspection goes further and may involve opening up parts of the chimney or adjacent structure to reach a suspected problem. It comes into play when a Level 1 or Level 2 turns up evidence of a hidden defect, like a cracked liner behind solid masonry or a gap that can’t be seen from inside the flue. In Kensington’s older homes, that usually means confirming whether a decades-old clay liner has failed in a spot the camera can’t fully resolve.
Camera Inspection
A camera inspection is the tool that separates diagnosis from guesswork, and it’s central to how we work in Kensington. We run a camera through the flue and share the footage on the spot, so you can see the spalling, the cracked tile, or the joint that’s given way. That footage is also what tells us whether a repair like a HeatShield ceramic resurfacing will do the job or whether a full stainless steel reline is the honest answer.
Trusted Brands We Service in Kensington
When a Kensington inspection turns up liner work, the materials matter as much as the diagnosis. We specify DuraFlex flexible liner systems for relining and Olympia Chimney components when a job calls for them, and we use HeatShield ceramic resurfacing when a deteriorating liner can be restored rather than replaced. Gelco products come into play for certain repair applications. These are professional-grade brands used by certified chimney specialists, not hardware-store substitutes. We don’t claim to stock parts; we match the right component to your chimney’s specific configuration and get it ordered. From inspection through the repair itself, the work stays in one place.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Inspection Problems We See in Kensington Homes
The problems in Kensington’s chimneys tend to repeat because the housing stock does. Here’s what inspections on these blocks turn up most.
- One flue assumed to serve the whole house. Many two-family homes here have multiple appliances venting into a single shared stack, which can cause cross-contamination and weak draft. A camera inspection is the only reliable way to confirm how the flues are actually divided.
- Spalling and cracked clay tile behind an intact exterior. A chimney can look solid from the roofline while the liner inside is flaking and cracked. Older brick and clay don’t age evenly, and the outside rarely tells the full story.
- Exhaust migrating between appliances. In homes built around 1920 where the furnace flue and water heater flue share a stack without proper separation, exhaust from one can leak into the other. A Level 2 camera inspection usually shows the deteriorated mortar joints and spalling that make this worse.
- Liner replacement recommended without evidence. Some of the worst upselling happens on chimneys like these, when a full reline gets sold without a camera run to justify it. A proper inspection may show that only localized joint repair is needed.
Pricing for Chimney Inspection in Kensington, NY
Inspection pricing in Kensington tracks the level of work. A Level 1 visual inspection typically runs $150 – $250 and is often done alongside a cleaning. A Level 2 camera inspection, the standard for most older two-family homes here, generally runs $250 – $400. A Level 3 inspection, which may involve opening up part of the chimney, runs higher and we quote it after we’ve seen the chimney. A camera inspection added as part of a cleaning is usually less than a standalone one. Freeze-thaw cycles here crack masonry and speed liner wear, so the condition of the flue affects how much time the inspection takes. Everything is per job by a written estimate, and the estimate is free. Call (855) 924-3713.
We Also Serve Cities Near Kensington
Kensington sits among neighborhoods with much the same housing stock and the same chimney problems, and we work across the surrounding area. If you’re in Kensington or nearby, we cover homes in Flatbush, Borough Park, Midwood, and Sunset Park as well. The coal-era chimneys and clay tile liners are familiar territory across all of them. Call for an inspection wherever you are on that map.
Serving Kensington, NY – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Inspection in Kensington
A cleaning removes creosote; it doesn’t show you the condition of the liner, and in Kensington’s older homes the liner is where the real problems hide. A camera inspection is the only way to see spalling clay tile, cracked joints, or cross-contamination between flues sharing a stack. A sweep last year tells you the chimney was dirty, not that it’s structurally sound. Call (855) 924-3713 for a camera inspection and an exact quote.
You know by looking inside it, not by judging the brick from the outside. Clay tile liners from that era are prone to spalling and joint failure, especially after decades of freeze-thaw cycles and appliance changes from coal to oil to gas. A Level 2 camera inspection shows whether the tile is intact, whether joints have given way, and whether a HeatShield resurfacing or a full reline is the right call. Call (855) 924-3713 to book one.
A Level 1 is a visual check of the accessible parts of the chimney; a Level 2 adds a camera run through the flue and a closer look at the connections and clearances. For most Kensington two-family homes with multiple flues in a shared stack, the Level 2 is the one that gives you real answers. It’s also the standard for a real estate transaction. Call (855) 924-3713 and we’ll tell you which level fits your chimney.
That smell usually means exhaust from one appliance is finding its way into another flue or into the living space, which points to cross-contamination in a shared stack. In these older homes the furnace, water heater, and sometimes a former stove flue all vent through one chimney, and without proper separation the exhaust migrates. A Level 2 camera inspection finds the source. Call (855) 924-3713 to schedule one.
Once a year is the working rule, and fall is the practical time here since the heating season runs from November to March. Kensington’s freeze-thaw winters and older masonry make an annual check worthwhile, especially if your chimney has a clay tile or unlined flue. If a property changes hands or you’ve had a chimney fire or a change in appliances, schedule a Level 2 regardless of timing. Call (855) 924-3713; estimates are free.
If your chimney in Kensington hasn’t been looked at inside lately, a camera inspection is the honest place to start. You’ll see exactly what we see, and we’ll tell you plainly when a repair can wait. Call (855) 924-3713 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bensonhurst.