Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Kensington
If you’re searching for chimney repair in Kensington, NY, the short answer is this: most of the repair work here involves chimneys built between roughly 1900 and 1940, and it rarely looks the way homeowners expect. The brick on the outside can look fine while the flue inside has been quietly failing for years. We’re chimney repair specialists who work these older Kensington houses often, and we know what the neighborhood’s chimneys tend to do. When something at the top of the house has gone wrong, call (855) 924-3713.
Why Kensington Homeowners Call Chimney Sweep Bensonhurst for Chimney Repair
Kensington’s chimney work is shaped by the neighborhood’s stock of early-20th-century single-family and two-family homes. Many of these houses have unlined or clay-tile-lined brick chimneys that were originally built for coal, then converted to oil and gas over the decades. Those aging flues are prone to spalling and internal deterioration, so a cleaning often turns up structural issues that a newer suburban house never faces.
That’s exactly why we lead with camera evidence. Nothing gets recommended until you can see the problem on the monitor for yourself. We’re not going to tell you that you need a new liner because a chimney is old; we’ll tell you when a flue is genuinely compromised and when it can safely wait a season.
Our technicians have up to 12 years of experience, and a good portion of it has been spent in houses on the blocks around Kensington and the two-family side streets off the main avenues. The same team that inspects also repairs, cap and crown included, so you’re not handed off between a sweeper and a mason. We answer 24/7, with fast dispatch from 7am to 7pm. Estimates are free, and the price is set per job by the written estimate before any work starts.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Kensington
A Kensington chimney usually needs more than one kind of work at once. Here’s how the main repair services break down for our local housing stock.
Mortar Repointing
Decades of freeze-thaw cycles in Kensington work their way into mortar joints, and the joints give out before the brick does. Repointing means grinding out the failed mortar and packing in fresh material matched to the original, which stops water from getting in behind the bricks. On a 1920s chimney, this is often the difference between a repair and a rebuild.

Spalling Brick Repair
Spalling is when the face of a brick flakes or pops off, usually after water gets in and freezes. It’s common on the older masonry chimneys around Kensington, especially on the colder, shadier side of a house. We cut out and replace the failed brick rather than patching over it, so the repair holds through the next winter.

Chimney Waterproofing
The single most effective thing you can do for an aging Kensington chimney is keep water out of it. Vapor-permeable waterproofing lets the masonry breathe while shedding rain, and it slows the spalling and rusted dampers that follow repeated wetting. This is often the least expensive step and the one that protects everything else.

Flashing Repair
Flashing is the metal where the chimney meets the roof, and it’s a frequent leak point on the slate and asphalt roofs common here. When flashing pulls away or corrodes, water runs down inside the chimney chase and shows up as a ceiling stain somewhere far from the chimney itself. We reseat and repair the flashing so the roof-to-chimney seam sheds water the way it should.
Tuckpointing and Chimney Rebuilding
When repointing alone won’t hold because the damage has spread too far, tuckpointing restores the joint profile on sound masonry, and a partial rebuild replaces a section that’s beyond saving. A rebuild is a real decision, so we show you the camera findings and the failing joints before we ever bring it up. We fit a new stainless steel liner only when the flue’s condition actually calls for it.
Trusted Brands We Service in Kensington
We work with professional-grade, industry-recognized materials rather than hardware-store substitutes. When a Kensington flue needs resurfacing, we use HeatShield’s ceramic flue-renewal system, which extends liner life without a full reliner replacement. For relining, we fit DuraFlex and Olympia Chimney flexible liner systems. We also draw on Gelco for cap and crown components and match the right part to each chimney’s specific configuration rather than defaulting to a one-size-fits-all piece. These are trade-grade components, and they matter because your chimney is a venting system first: the material in the flue is what stands between combustion gases and the inside of your home.
Common Chimney Repair Problems We See in Kensington Homes
- Coal-era flues venting modern appliances. Many Kensington chimneys were built unlined or with clay tiles sized for coal, then converted to gas or oil. The mismatch causes condensation and accelerated spalling that goes unnoticed until a camera inspection reveals the internal debris.
- Multiple flues sharing one stack. In Kensington’s two-family homes, chimneys often have two or more flues that once served separate coal furnaces and kitchen stoves. They’re frequently cross-connected or share a single stack, which creates venting hazards only a careful camera inspection can find.
- Freeze-thaw damage to crowns and flashing. Kensington’s hot summers and chilly winters set up a freeze-thaw cycle that cracks mortar crowns and flashing. Water gets in, rusts dampers and delaminates clay tiles, and it’s easy to mistake the resulting stain for simple creosote buildup.
- Water infiltration mistaken for chimney-tar. A leaky crown or flashing lets water run down inside the flue, and the mess it leaves can look a lot like a dirty chimney. Cleaning alone won’t fix it; the water source has to be found first.
See the difference
Before
After
Before
After
Before
AfterHow a Typical Kensington Chimney Repair Goes
In a typical repair call in Kensington, a technician runs a camera down an unlined or clay-tile flue and finds spalling brick and deteriorated mortar joints behind the smoke chamber, often right where a modern gas appliance was vented into a stack that was never designed for it. Because many of these chimneys have multiple flues serving separate appliances, the technician also has to verify that no cross-contamination exists before the chimney goes back into service. When it’s warranted, the fix is to rebuild the affected section with new brick and mortar, then either install a stainless steel liner or apply HeatShield resurfacing compound to restore safe venting. And when it isn’t warranted, we say so.
Pricing for Chimney Repair in Kensington, NY
Repair pricing in Kensington reflects the housing stock: these are older masonry chimneys, and what’s found behind the smoke chamber usually drives the number. A typical spot mortar repointing job in Kensington runs roughly $400 to $1,200 depending on how much of the stack is involved. Spalling brick repair, where individual units are cut out and replaced, generally lands between $500 and $1,500. Chimney waterproofing is commonly $300 to $700 for the stack. Flashing repair typically runs $300 to $900 depending on the roof and access. A partial or full chimney rebuild is a bigger undertaking, usually $2,500 to $8,000 or more, because it’s real masonry. Every quote is free and written, with the price set per job by that estimate, so you see the line items before you commit.
We Also Serve Cities Near Kensington
Kensington sits among a cluster of neighborhoods with the same era of housing, and we work throughout them: Flatbush, Borough Park, Midwood, and Sunset Park. If your chimney is on a pre-war or early-1900s house anywhere nearby, the repair principles are the same. Call (855) 924-3713 to book a sweep and inspection and start with a camera look.
Serving Kensington, NY – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Kensington
You find out with a camera inspection, because a standard visual look from the roof cannot see cross-connection inside a shared stack. In Kensington’s two-family homes, flues that once served separate coal furnaces and stoves now often vent separate appliances, and a shared stack can leak flue gases from one into the other’s living space. We run a camera through each flue and check the separation before we call the chimney safe. Call (855) 924-3713 to book the inspection.
Crumbling mortar usually means repointing, not a rebuild, as long as the brick itself is still sound. Repointing grinds out the failed joints and packs in fresh mortar matched to the original; a rebuild only becomes necessary when the brick faces have spalled away too far to hold new mortar. On a 1920s Kensington chimney, we check the brick condition before recommending either. Call (855) 924-3713 for a free written estimate.
An unlined flue venting a modern gas furnace is generally not safe without correction, because gas appliances produce moisture that attacks unprotected brick and the flue was never sized for it. Coal-era chimneys in Kensington are often unlined or clay-tile-lined and were built for a very different appliance. The fix is usually a stainless steel liner or a HeatShield resurfacing, but only after the camera confirms what’s actually going on inside. Call (855) 924-3713 to find out for certain.
Look for water stains on the ceiling or chimney chase, rusted damper parts, or spalling near the top of the stack, since those point to water getting in at the crown or flashing. In Kensington’s freeze-thaw climate, cracked crowns and pulled flashing are common culprits, and the leak often shows up far from the chimney itself. We trace the water source rather than guessing, and flashing repair typically runs $300 to $900. Call (855) 924-3713 for a free estimate.
A Level 1 is a basic visual check for a chimney in known-good condition; a Level 2 adds a camera run through the flue, which is what older Kensington homes usually need; a Level 3 goes further, opening up concealed parts of the chimney when a serious problem is suspected. For a converted coal-era flue or a multi-flue two-family stack, the Level 2 camera inspection is the one that catches what a visual look misses. Call (855) 924-3713 to book one.
If your chimney is on an older Kensington house and something doesn’t look right, the place to start is a camera inspection you can watch for yourself. Call (855) 924-3713 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bensonhurst.