Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Inspection Across Borough Park
Borough Park homeowners call us because a chimney here is rarely just a chimney. On the brick two- and three-story buildings that line 13th Avenue and the blocks off Fort Hamilton Parkway, factory-built fireplaces often share a chase with a boiler and a water heater venting into the same stack. A proper chimney inspection has to account for all of it. We connect you with local technicians who know that pattern, who work through chimney inspection in a single visit, and who explain what they found in plain terms. Call (855) 924-3713 to book yours.
Why Borough Park Homeowners Call Chimney Sweep Bensonhurst for Chimney Inspection
We work in Borough Park often enough that the local building patterns aren’t a surprise. The dense multi-family and semi-detached brick stock means our technicians routinely inspect shared masonry stacks where more than one unit and more than one appliance tie into a single flue. That’s a different job from a suburban single-family sweep, and it needs someone who thinks about fire separation and liner condition from the first minute.
Our technicians have up to 12 years of experience, and they bring both camera equipment and a working knowledge of the professional-grade brands that turn up in these homes: DuraFlex liners, HeatShield ceramic resurfacing, Olympia Chimney vent components. Every inspection comes with a camera inspection and a photo report, so you see what we see before anything is recommended. We answer 24/7 and dispatch fast, 7am to 7pm, Sunday through Friday.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Inspection Services in Borough Park
Level 2 Inspection
This is the inspection most Borough Park homes actually need, and it’s the one we emphasize here. A Level 2 goes beyond the accessible firebox to the attic, the crawl spaces, and the chase itself, which is exactly where the prefab-to-masonry connections on these buildings hide problems. If you’ve had a fireplace installed during a renovation, a Level 2 is the inspection that accounts for the manufacturer-specific venting tied into the old stack.
Camera Inspection
Behind newer drywall and chase panels, a disconnected or corroded vent section can sit completely out of sight. A camera inspection runs the flue and shows you the interior condition on a screen, with photos you keep. That matters on a Borough Park shared stack where a boiler, a water heater, and an apartment fireplace all rely on the same chase staying intact.
Flue Inspection
A flue inspection focuses on the pathway itself: liner condition, draft, and whether the appliance venting matches what the flue was built for. On post-war brick Borough Park homes with oil-to-gas conversions and long heating seasons, cracked clay liners and spalling mortar turn up often. The flue check tells you whether it’s a cleaning, a reline, or a repair.
Level 1 Inspection
A Level 1 is the routine annual check for a chimney that’s been used normally with no changes to the system. It covers the readily accessible portions: firebox, damper, smoke chamber, flue, and cap. It’s the right starting point for an unchanged setup, though on a shared Borough Park stack it sometimes leads to a Level 2 once the technician sees how many appliances are tied in.
Trusted Brands We Service in Borough Park
We specify trade-grade components because they hold up in these older shared stacks. DuraFlex flexible liner systems suit the offsets and angles you find in retrofitted Borough Park chases. HeatShield ceramic flue-resurfacing extends liner life where the walls are deteriorating without going to a full reline. Olympia Chimney, Gelco, Famco, and Copperfield supply the vent caps and components that let us match the right part to each chimney’s specific configuration rather than defaulting to a hardware-store substitute. We don’t stock parts on a truck; we source to the job and keep turnaround quick.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Inspection Problems We See in Borough Park Homes
Here’s what our technicians run into on Borough Park stacks, and why a generic inspection often misses it.
- A factory-built fireplace vented into a shared masonry chimney. The prefab unit was tied into a chase that still vents the boiler and water heater, which raises draft interference and fire-separation questions a Level 2 is built to sort out.
- A prefab chase cap or flashing that ignores the original mortar crown. When the new cap doesn’t accommodate the old stack, water tracks down the flue liner and spalls the brick, and freeze-thaw winters make it worse each season.
- Manufacturer-specific vent sections hidden behind newer drywall. Gelco or Copperfield components can be walled into a chase panel, so a basic Level 1 never sees a disconnected or corroded section until a camera inspection reveals it.
- Multiple appliances on one chase. A boiler, a water heater, and an apartment fireplace in a single chimney is common in the subdivided walk-ups here, so a routine cleaning can turn into a liner and draft-safety evaluation.
Pricing for Chimney Inspection in Borough Park, NY
Pricing is per job and set by the written estimate, but here are the typical ranges Borough Park homeowners see. A Level 1 inspection usually runs $100 to $175. A Level 2 with camera access typically runs $200 to $400, reflecting the added scope on a shared stack. A Level 3, which opens concealed areas of the chase, starts higher and is quoted after the technician sees the configuration. A standalone camera inspection runs about $150 to $300. What moves the number is access, how many appliances share the chase, and whether concealed sections need opening. The estimate is free, and nothing is recommended until you’ve seen the camera evidence and photo report yourself.
We Also Serve Cities Near Borough Park
Our inspection work reaches the communities around Borough Park as well. Homeowners in Sunset Park, Kensington, Dyker Heights, and Bensonhurst get the same camera inspection, photo report, and brand-specific venting checks. If your building has a shared masonry chase or a factory-built fireplace tied into an older stack, the inspection approach is the same one we bring to Borough Park. Call (855) 924-3713 for a free estimate.
Serving Borough Park, NY – Our Local Coverage Area
We serve Borough Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Inspection in Borough Park
Because the prefab unit is usually tied into an original masonry chase that still vents the boiler and water heater, and a Level 1 doesn’t reach into the chase to check that connection. The Level 2 covers the manufacturer-specific venting, the cap, the damper, and the smoke chamber, which is where water intrusion and draft problems show up above the firebox. Call (855) 924-3713 for an exact quote – estimates are free.
You usually can’t from the ground, because the tell is whether the cap and flashing actually sit over the original mortar crown. When they don’t, water tracks down the flue liner and pops the brick face, and a freeze-thaw winter accelerates it. A technician checks the crown, the flashing, and the cap together and shows you photos of what’s mismatched. Call (855) 924-3713 to book the inspection.
It shows the interior of the flue, including any vent section walled behind newer drywall or a chase panel. That’s where a disconnected or corroded Gelco or Copperfield component can hide on a Borough Park retrofit, invisible to a Level 1. The camera runs the flue and captures photos you keep. Call (855) 924-3713 for an exact quote.
A Level 2 is the appropriate starting point, because the shared chase raises draft and fire-separation questions a Level 1 can’t answer. The technician confirms how each appliance vents, checks the liner and smoke chamber, and runs a camera where access allows. If concealed areas need opening, a Level 3 is quoted after that. Call (855) 924-3713 – estimates are free.
Yes, because the fireplace isn’t the only appliance on that chase. A boiler and water heater vent year-round, and the shared stack takes the wear even when the fireplace sits idle. An annual inspection catches a mismatched cap, a spalled crown, or a corroded vent section before the next freeze-thaw winter makes it worse. Call (855) 924-3713. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Call (855) 924-3713 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bensonhurst.